Manual

PICTURE-IN-PICTURE (PIP)

(_) FREEZE button (With PIP ON)

If you wish to freeze the sub-picture, press the FREEZE button. This is convenient when trying to write down the address for

a mail order company, recording statistics for a sporting event, etc. To return the picture to motion, press the FREEZE button

again.

NOTE: The FREEZE function will only operate when SINGLE PIP mode is chosen.

(_) FREEZE button (With PIP OFF)

Press the FREEZE button to freeze the picture, depending on the mode selected (SINGLE or STROBE).

To change FREEZE modes, use the PIP MODE button to cycle through the two different modes.

SINGLE FREEZE

Press the FREEZE button to freeze one frame of the picture you are currently viewing. Press this button again or PIP to return to

normal viewing.

FREEZE

STROBE FREEZE

Press the FREEZE button to freeze three frames of the picture you are currently viewing. Press this button again or PIP to return

to normal viewing. This feature is useful for viewing a moving picture that has many details, for example, a close play in a sporting

event or a golf swing.

FREEZE FREEZE

--Q

I ACAUTION: A pattern burn may develop if the sub-picture is left in the same corner permanently. If the PIP feature is used

frequently, occasionally MOVE the sub-picture using the THUMB STICK _1,I_, A, or V.

NOTES: 1. Each freeze frame is delayed about 0.1 (1/10) second.

2. When viewing a COMPONENT: Y-PBPR INPUT, FREEZE is not allowed.