User Guide

54
Position Adjustment
Vertical picture position can be adjusted for Panoramic, Zoom, C14:9L, and 14:9 Zoom mode as follows.
1. Press
buttons while operating the picture size display.
2. “Position” display will appear.
3. Adjust the position by
buttons.
Adjustment range of each picture size are as shown below.
Panoramic: -12 to+12 (The position cannot be adjusted in Panoramic 2 mode.)
Zoom: -31 to+ 31
C14:9L and 14:9 Zoom: -16 to+ 16
*When 1080i/60 component signal is received, it can be adjusted only 0 to +1.
Size Adjustment
Full Mode
Whilst displaying a picture of 1080i format in AV4, HDMI1, HDMI2, or RGB input, the full mode can be switched further
between Full1 and Full2 with
buttons on the remote control.
By selecting Full2, you can see the whole image of 1080i format on the screen display from the input terminals.
Depending on the input signal or connecting device, the screen display has unnecessary blanking or noise at the edges.
Considering the case, the default setting is Full1 which enlarges the vertical size not to display the blanking and noise.
NOTE
The screen saver function does not work at Full2 mode.
This function is available only for 42PD9700 U/C.
FUNCTION (continued)
Size Switching (continued)
Position + 31
Press▲
Position - 31
Press▼
Panoramic Mode
Whilst displaying a picture except RGB input, the panoramic mode can be switched further between Panoramic 1 and
Panoramic 2 with
buttons on the remote control.
By selecting Panoramic 2, the vertical size is scaled down so that you can see the whole image without blanking ; for
example, you can see the subtitle at the bottom of screen without lacking.
NOTE
The function does not work when selecting Auto [Panoramic].