Manual

CONNECTING EXTERNAL VmDEO SOURCES

iiiiiiiiiiiiiiiiiiiiiiiiiiiiii

iiiiiiiiiiii i! i!ili i!ii!

The exact arrangement you use to connect the VCR, camcorder, laserdisc player, DVD player, or HDTV Set Top Box to your TV set is

dependent on the model and features of each component. Check the owner's manual of each component for the location of video

and audio inputs and outputs.

The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your

particular assortment of components and features. For best performance, video and audio cables should be made from coaxial

shielded wire.

Before Operating Externam Video Source

The input mode is changed every time the VIDl-VID5 button is pressed as shown below. Connect an external source to the iNPUT

terminal, then press the VID1--VID5 button as necessary to view the input source (see page 22).

NOTE:

INPUT BJIODESELECTION ORDER

(ANTENNA) (INPUT)

AntA YPBP_;1

When the TV is set to VIDEO and a video signat is not received from the VIDEO iNPUT JACK on the back panel of the

TV (Le. VCR/laserdisc player, etc. is not connected or the video device is OFF), the set will appear to be OFF.