Manual

Manual Convergence Adjustment Mode
NOTES: 1. Please turn ON your television for at least 20 minutes before using this feature.
2. Auto Adjustment Mode is recommended, if convergence is still not acceptable, use the Manual Adjustment Mode.
3. If Auto Adjust mode is selected or the Magic Focus button is pressed, all manual adjust mode settings will be erased.
Using the Remote Control, select SETUP-MAGIC FOCUS TUNE UP-MANUAL ADJUSTMENT MODE-START to access convergence
crosshatch pattern. The adjustment point is indicated by the Adjustment Point Cursor.
To rvlove Adjustment Point
To move the adjustment point cursor using the CURSOR buttons, the Adjustment Cursor must be WHITE. Another way to move the
Adjustment Point Cursor is to press the following buttons: [2] up, [4] left, [5] down, [6] right, if you use the number buttons while the
adjustment point is WHITE, it will change to RED.
To Change the Comor of Adjustment Point
Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE_=)= Green color is fixed and cannot be adjusted.
To Adjust the Convergence
Move the Adjustment Cursor to the point to be adjusted. Use the CURSOR to match the RED and BLUE colors to GREEN (reference
color)= Properly aligned, all three colors should appear white=
MEnU
_Z_>...............
Video ]
Audlo ]
Aspect ]
Chan. Manager ]
Locks J
[ , MoveGELJSo7 ]
........_ii!ii!;ii;_¸_ @i;N¸ 4_ @!_....
Setup
Nent_ Pr e Fer en_e
se_ the Clo_k
set lhe Color ¸ Sy_ten,
Se_ 8lack S_de P_mel
Set Ever, t 1 h_er ¸
Set Clo_ed C_,I_O_,,;
Abot_t Your ¸ l_/
HOW, _SELI 5e_e_t
Setup
liiii___!i_i!_;;;ii_ _iiii_i i_!!!!!!!!!!!!!!!!!!!!!!!!!i_
Allgns the Red, Green, and Blue
colors to correct for Magnetlc
Znfluences.
Adjustment Mode
Manual
Zf you wan_ to adjust now._-_
I _ Hove rsg[j Re_utn I
................;ii;_i_;__)_ ili_i,_i!__¸¸¸¸¸¸_,,,,,,,,,,,,,i!i!:i:i_;_.....
Adjustment Point
Cursor
/
........
....... /____
If convergence is acceptable after Manual Convergence adiustment, press EXIT button to access menu mode.
117 Manual Adjust
Please Enter Number.
0.Cancel and go to Nor'ma] Node.
1.Done and go to Normal Node.
2.Back to Adjust Mode
3.Factory Reset and back to
Adjust Node.
0 3.Select
Press the [0] button on the remote controt to CANCEL adjusted data and return to main picture.
Press the [1] button on the remote control to SAVE adjusted data and return to main picture.
Press the [2] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern).
Press the [3] button on the remote control to recall the factory pre-set convergence data.
52