- hitachi Opertaing guide Projection color tv 46GX01B 50GX20B

HOOK-UP CABLES AND CONNECTORS

Most video/audio connections between components can be made with shielded video and audio cables that have

phono connectors. For best performance, video cables should use 75-Ohm coaxial shielded wire. Cables can be

purchased from most stores that sell audio/video products. Below are illustrations and names of common

connectors. Before purchasing any cables, be sure of the output and input connector types required by the

various components and the length of each cable.

300-Ohm Twin Lead Connector

This outdoor antenna cable must be connected to an

antenna adaptor (300-Ohm to 75-Ohm).

"F" Type 75-Ohm Coaxial Antenna Connector

For connecting RF signals (antenna or cable TV) to the

antenna jack on the television.

Phono Connector

Used on all standard video and audio cables which

connect to inputs and outputs located on the television's

rear jack panel and front control panel.

S-Video (Super Video) Connector

This connector is used on camcorders, VCRs, and

laserdisc players with an S-Video feature in place of the

standard video cable to produce a high-quality picture.

ANTENNA CONNECTIONS TO REAR JACK PANEL

VHF (75-Ohm) antenna/CATV (Cable TV)

When using a 75-Ohm coaxial cable system, connect the outdoor antenna or CATV coaxial cable to the ANT A

(75-Ohm) terminal. If you have a second antenna or cable TV system, connect the coaxial cable to the ANT B

terminal.

To outdoor antenna or CATV cable

VHF (300-Ohm) antenna/UHF antenna

When using a 300-Ohm twin lead from an outdoor antenna, connect the VHF or UHF antenna leads to screws of

the VHF or UHF adaptor. Plug the adapter into the antenna terminal on the TV.

To outdoor VHF or UHF Antenna

When both VHF and UHF antennas are connected

Attach an optional antenna cable mixer to the TV antenna terminal, and connect the cables to the antenna mixer.