- hitachi Opertaing guide Projection color tv 46GX01B 50GX20B

REAR SPEAKER TERMINAL CONNECTIONS

CONNECT AFTER TURNING THE POWER TO THE TV OFF.

Press the Right Speaker red button and insert the positive (+) lead wire into the hole next to the button. Once the

wire is in place, pull the red button back to original position and the wire is locked into place. In the same manner,

press the Right Speaker black button and insert the negative (-) lead wire. Repeat this procedure for the Left

Speaker.

CAUTION: Do not short speaker terminal, (do not connect a wire directly across any two terminals). This

could cause damage to your audio outputs or other damage to your TV.

CAUTION: Do not connect speakers simultaneously to the REAR SPEAKER terminal of the Projection

TV and an external amplifier. This could damage both the TV and the speakers. Your TV was designed to use 8-

Ohm speakers only. Any other type may degrade the audio performance of your entertainment system..

TIPS ON REAR PANEL CONNECTIONS

S-Video connections are provided for high performance laserdisc players, VCRs etc., that have this feature. Use

these connections in place of the standard video connection if your device has this feature.

If your device has only one audio output (mono sound), connect it to the left audio jack on the TV.

Refer to the operating guide of your other electronic equipment for additional information on connecting your

hook-up cables.

A single VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line

output. (INPUT 1 in example on page 11.) Refer to your VCR operating guide for more information on line input-

output connection.

You may use VIDEO or COMPONENT: Y-CB-CR inputs to connect to INPUT 2, but only one of these may be

used at a time.