Operation Manual

GB-16
• If a power failure occurs or the unit is disconnected from the mains, the clock setting will
be lost.
Setting the Clock Automatically
Tune into a RDS station, press and hold the
DISPLAY
button. The clock will automatically
update.
Display the Clock
In any source mode, the built-in clock shows the time on the display by press the
CLOCK
button.
Sound Quality
Adjusting the Volume
To increase or decrease the volume, rotate the volume control knob (
- VOLUME +
) on the unit or
press the volume up/down buttons (
VOL +/-
) on the remote control.
Adjusting the Super Bass
You can reinforce the bass sound to maintain rich, full bass at low volume.
Press the super bass button (
S-BASS
) on the remote control to get the effect, the “ ” will lit
on the front panel. Press the Super Bass button (
S-BASS
) again to cancel the effect.
Controlling the Loudness
This unit has a loudness function, which can automatically increase the bass sound effect at
low volume. It can also increase the bass sound effect at high volume, but it will be relatively
less when it is at high volume. Press the loudness button (
LOUDNESS
) to obtain the loudness
function, the “
” will display on the front panel, press again will disappear.
Presetting Equalizer
You can adjust the sound reproduced simply by choosing from 5 preset equalizers.
During play, press the preset equalizer button (
P-EQ
) on the remote control repeatedly to
select:
• [FLAT] (FLAT)
• [POP] (pop)
• [JAZZ] (jazz)
• [ROCK] (rock)
• [CLASSIC] (classic)
Changing the Front Panel Darkness
This unit has three brightness levels for you to adjust the clock display. Press the dimmer
control button (
DIM
) on the front panel or the remote control repeatedly to choose the desired
brightness.
Downloaded from www.vandenborre.be