Operation Manual

GB-17
Listening to Radio Broadcasts
Caution: Before listening to the radio, please check that the FM Antenna is correctly connected
and adjusted for length and direction.
Tuning in to a Station
1. Repeatedly press the function select button (
FUNCTION
) on the unit or directly press the tuner
function button ( ) on the remote control to select tuner source.
- The word “TUNER” will be displayed on the front panel.
2. Select a station using one of the following methods.

Auto Tuning
Press and hold the tuning backward/forward button (
L
/
BF
) on the unit or tuning backward/
forward button (
D
/
C
) on the remote control for one second or more, the frequency
changes down or up automatically until a station is found.

Manual Tuning
Repeatedly press the tuning backward/forward button (
L
/
BF
) on the unit or tuning back-
ward/forward button (
D
/
C
) on the remote control to change the frequency until you nd
the station you want.

Preset Tuning (Available only after the stations are preset)
Repeatedly press the preset up/down button (
H
/
G
) to select the desired preset number.
Its band and frequency are displayed on the front panel.
Program radio stations
You can program a maximum of 20 preset radio stations (FM).

Automatically
Press and hold the programme button (
PROG
) on the remote control for two second or more
to activate automatic program mode.
- [AUTO] is displayed.
- All available stations are programmed.
- The rst programmed radio station is broadcast automatically.

Manually
1. Tune to a radio station.
2. Press the programme button (
PROG
) on the remote control to activate program mode.
- The preset number will blink.
3. Press the
H
/
G
button to allocate a number to this radio station.
Note: If you select more than 20, the preset number will be changed to “1” automatically.
4. Press the programme button (
PROG
) on the remote control again to store the station.
5. Repeat above steps 1 to 4 for each station you want to store in memory with a preset
number.
Note: If the system is unplugged or if a power failure occurs, the preset stations will not be
erased.
To change the FM Reception Mode
Press the stereo/mono select button (
MODE
) on the remote control to select the Stereo or Mono
channel to receive the best FM reception mode.
Downloaded from www.vandenborre.be