Operation Manual

GB-3
For safety reasons, do not remove any covers or attempt to gain access to the inside of the
product. Refer any servicing to qualied personnel.
Do not attempt to remove any screws, or open the casing of the unit; there are no user
serviceable parts inside, refer all servicing to qualied service personel.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR
BACK), NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE
TO DRIPPING OR SPLASHING.
Note:
- This unit will become warm when used for a long period of time. This is normal and does not
indicate a problem with the unit.
- If unusual conditions occur in the display or buttons, switch the unit off then turn on the unit
again.
- The rating label is located on the base of the unit.
- The marking information is located at the bottom of apparatus.
Laser Product
This product is equipped with low power laser equipment. For your own safety do not remove
any covers or take the product apart. Repair work must be carried out by qualied personnel.
DANGEROUS VOLTAGE
There is high voltage, that may be of sufcient magnitude to constitute a risk of electric
shock to persons is present within this product enclosure.
ATTENTION
The owner manual contains important operating and maintenance instructions, for your
safety, it is necessary to refer to the manual.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Caution:
This product is equipped with low
power laser equipment inside, for your
safety, don’t open the laser radiation
protective equipment. Don’t look at the
laser radiation district when the equip-
ment is operating.
CLASS 1
LASER PRODUCT
Downloaded from www.vandenborre.be