User manual

English

QR34962



REPLACING DISC IN ROUND DVD HOLDER

1Open SIDE A of the Round DVD Holder, and

replace the disc in the holder with the SIDE A

mark or label surface facing up, taking care not

to touch the disc surface.

2Close SIDE A of the Round DVD Holder, and

push it to lock the release levers at positions (3).



WHEN THE HINGE OF ROUND DVD HOLDER COMES OFF

1Push the hinged portion of the holder piece

marked SIDE A with thumb and middle finger,

and warp it in the direction of arrows (4).

2Fit the hinged portion of the other holder piece

into the warped hinge portion.

Note:

• Handle the disc carefully so that no scratch, dirt,

fingerprint or dust adheres to the recording/playback

surface.

• When not using the Round DVD Holder, store it in case:

Do not leave a bare holder as is.

• Be careful of drop or impact: If you drop the Round DVD

Holder, the disc may pop out.

• Do not subject the Round DVD Holder to force.



DISC CLEANING

Use a soft, dry cloth to lightly wipe off any dust,

dirt, etc. adhering to disc, as shown in the figure.

Never use solvent. Do not use thinner, water, anti-

static spray, etc. to clean disc.

SIDE A

mark

OPEN marks

SIDEAmarksideor

Label surface

SIDEAmarkside

Hinged portions

Approx. 90°

Use soft cloth to clean

from inner to outer

circumference in axial

direction.