User manual

chapter 2_Setups

Cautions

• During and after charging, the battery will be warm, but this does not indicate a fault.

• If the POWER indicator on AC adapter/charger blinks, remove the battery once, and then reattach it. If

the POWER indicator still blinks, the battery may be faulty.

• If the ambient temperature is a little too high or low, the CHG. indicator or CHG.80 indicator on AC

adapter/charger will blink at 6-second intervals. In this case, charging is possible, but it will take

longer than usual.

• If the ambient temperature is too low or too high, the CHG. indicator or CHG.80 indicator on AC

adapter/charger will blink at one-second intervals, showing that charging will not be possible.

Attaching Battery to DVD Camcorder

Caution

• Make sure that the battery is securely attached: Incomplete attachment could cause the battery to fall,

resulting in damage.

1. Pull out the viewfinder fully and raise it.

2. Align the top of battery with the top sur-

face of battery attachment platform of

DVD camcorder.

3. While fitting the battery onto the DVD

camcorder, slide it downward until a

click is heard.

Removing Battery

After using the DVD camcorder, remove the battery from it.

Cautions

• For safety, be sure to turn the DVD camcorder off before attaching or removing the battery.

• If the battery remains attached, minute level current will flow even if the DVD camcorder is off, and

the battery will discharge.

2 · 3