Instruction Manual CD-ROM DRIVE CDR-8130

Disc label side

Push

Disc Tray

120 mm Disc

Disc label side

Push

Disc Tray

80 mm Disc

IMPORTANT

- Do not press the OPEN/CLOSE button while the host computer is accessing

the disc. It may caused an error.

- When not using the CD-ROM Drive, keep the Disc Tray closed. It will prevent

the entry of the dust and dirt, and reduce the requirements for disc and lens

cleaning

If you do not observe the following items, troubles, such as that the Disc Tray can

not be opened or can not be closed, may occur or it may cause damage to the

mechanism of the CD-ROM Drive.

- Never use a damaged, broken or deformed disc.

- Do not press down hard on the Disc Tray when opening and closing the Disc

Tray.

EMERGENCY EJECT PROCEDURE

Only in case of emergency:

If the Disc Tray does not open when the OPEN/CLOSE Button is pressed, make

sure that the power of the CD-ROM Drive is turned on and software lock function

has not been used. If the Disc Tray still will not open, the CD-ROM Drive’s

Manual Emergency Eject mechanism may be activated.

This should be used only in case of emergency.

REMOVAL PROCEDURE

1. Turn off the CD-ROM Drive and wait at least 15 seconds till the disc stops

rotating.

2. Insert the Eject bar (for example, a straightened paper clip) into the Manual

Emergency Eject Hole about 25 mm (1 inch).

3. Pull the Disc Tray

CAUTION