Datasheet
11
ENGLISH
WARNING
►Before taking care of the air lter, make sure the power cable is not plugged in, then
allow the projector to cool sufciently.
►Use only the air lter of the specied type. Do not use the projector without the air
lter or the lter cover. It could result in a re or malfunction to the projector.
►Clean the air lter periodically. If the air lter becomes clogged by dust or the like,
internal temperatures rise and could cause a re, a burn or malfunction to the projector.
(1) Press the MENU button to display a menu.
(2)
Point at the “FILTER TIME” using the ▼/▲ button, then press the ► button. A dialog will appear.
(3) Press the ▲ button to select RESET on the dialog. It performs resetting the lter time.
NOTE • Please reset the lter time only when you have cleaned or replaced the air lter, for a
suitable indication about the air lter.
• The projector may display the message such as “CHECK THE AIR FLOW” or turn off the
projector, to prevent the internal heat level rising.
Filter cover
Filter cover knobs
Filter unit
Filter cover
Filter frame
Filter (ner meshed)
Filter (larger meshed)
Please check and clean the air lter periodically. When the indicators or a message prompts you to
clean the air lter, comply with it as soon as possible. The air lter has two kinds of lters inside.
Replace the lters when they are damaged or too soiled. To prepare the new lters, make contact
with your dealer and tell the following type number.
Type number = MU05661
1.
Turn the projector off, and unplug the power cord. Allow the projector
to sufciently cool down.
2.
Use a vacuum cleaner on and around the lter cover.
3.
Pull the lter cover knobs while lifting it, to take the lter unit off.
4.
Use a vacuum cleaner for the lter vent of the projector and both sides
of the lter unit.
5.
Pull the lter frame’s knob up while holding the lter cover to remove
the lter frame, then take the lters out.
6.
Set new lters where former lters were. Put the larger meshed lter
into a lter cover rst. Then put the ner meshed lter on the larger
meshed one.
7.
Put the lter frame back where it was.
8.
Put the lter unit back into the projector.
9.
Turn the projector on and reset the lter time using the FILTER TIME
item in the EASY MENU.
When you replace the lamp, please replace the air lter. An air lter of
specied type will come together with a replacement lamp for this projector.
I
f the lters are damaged or too soiled, replace them according to the following
procedure number 5 to 7. Otherwise, please jump to the procedure number 8.
Air filter