Operation Manual

English
6
(Guide
plate)
STANDARD ACCESSORIES
(1) Case (Molded plastic) ............................................... 1
(2) Side Handle ................................................................ 1
(3) Stopper ........................................................................ 1
(4) Hexagon Bar Wrench (for 6 mm screw) ............. 1
(5) Hexagon Bar Wrench (for 5 mm screw) ............. 1
(6) Hammer Grease A .................................................... 1
(7) Dust Cover ................................................................. 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Through-hole drilling (Rotation + Hammering)
(1) Drill bit (Spline shank)
Overall length: 400 mm
External dia.: 12.7, 25.4, 38.1 mm
2. Anchor hole drilling (Rotation + Hammering)
3. Large dia. hole boring (Rotation + Hammering)
APPLICATIONS
䡬 Drilling holes in concrete
䡬 Drilling anchor holes
䡬 Crushing concrete, chipping, digging, and squaring
(by applying optional accessories)
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
(2) Taper shank
adapter
(Spline shank)
(1) Drill bit (taper shank)
(1) Center pin
䢇 Applied to core bits from 38 mm to 105 mm
(2) Core bit
䢇 External dia. 50, 105 mm (with guide plate)
(3) Core bit shank
䢇 Applied to core bits above 38 mm
4. Crushing (Hammering)
5. Groove digging and edging (Hammering)
6. Asphalt cutting (Hammering)
7. Syringe (for chip removal)
8. Hammer grease A
500 g (in a can)
70 g (in a green tube)
30 g (in a green tube)
Optional accessories are subject to change without
notice.
Taper shank
adapter
A-taper
B-taper
Application drill bit
Taper shank adapter formed A-
taper or B-taper is provided as
optional accessory, but drill bit for
it is not provided.
(3) Cotter
(1) Center
pin
(2) Core
bit
(3) Core bit
shank
(Spline shank)
(1) Bull point
Overall length: 300 mm
(1) Cold chisel
Overall length: 300, 460 mm
(1) Cutter
Voltage (by areas)* (110V, 115V, 120V, 127V, 220V, 230V, 240V)
Power input 950 W*
Capacity Drill bit: 40 mm
Core bit: 105 mm
No load speed 180 – 360/min.
Full-load blow 1400 – 2800/min.
Weight (without cord, side handle) 6.8 kg
*Be sure to check the nameplate on product as it is subject to change by areas.
SPECIFICATIONS