Operation Manual

26
English
11. Do not insert foreign object into the air ventilation
slots of the charger.
Inserting metal objects or inflammables into the
charger air ventilation slots will result in electrical
shock hazard or damaged charger.
12. Wear ear protections
Exposure to noise can cause hearing loss.
13. When mounting a bit into the keyless chuck, tighten
the sleeve securely. If the sleeve is not tight, the
bit may slip or come off, causing injury.
CHARGER
Model UC12SD
Charging time Approx. 1 hour (at 20°C)
Charging voltage 12 V
Weight 1.4 kg
SPECIFICATIONS
POWER TOOL
STANDARD ACCESSORIES
Capacity
Model DV12DV
No-load speed (Low/High) 0 – 350/0 – 1250 min
–1
No-load impact rate (Low/High) 0 – 5250/0 – 18750 min
–1
Brick 10 mm
Drilling Wood 18 mm
Metal Steel: 10 mm, Aluminum: 10 mm
Driving
Machine screw 6 mm
Wood screw 5.1 mm (diameter) × 32 mm (length) (Requires a pilot hole)
Rechargeable battery (FEB12S) Ni-Cd battery, 12 V
Weight 1.9 kg
OPTIONAL ACCESSORIES ......(sold separately)
1. Battery (FEB12S)
2. Drill bit for brick
Diameter, 6.5 mm, 8 mm, 9.5 mm, 10 mm
Optional accessories are subject to change without
notice.
1 Plus driver bit (No. 2 × 55L) .........1
DV12DV
2 Charger (UC12SD) .............................1
3 Plastic case..........................................1
4 Hook .....................................................1
Standard accessories are subject to change without
notice.
APPLICATIONS
䡬 Drilling of brick and concrete block, etc.
䡬 Driving and removing of machine screws, wood
screws, tapping screws, etc.
䡬 Drilling of various metals.
䡬 Drilling of various woods.
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the impact drill, charge the battery as
follows.
1. Insert the battery in the charger.
Position the battery so that the nameplate faces
toward the nameplate of the charger and press in
the battery until it comes into contact with the
bottom surface. (See Figs. 1 and 3.)
2. Connect the charger power cord to the receptacle.
Connecting the power cord will turn on the charger
(the pilot lamp lights up).