Video Recorder User Manual

109
Additional Information
Note when transferring this camcorder or discarding discs and cards
• The “Format” function on this camcorder will only change the file control information.
It will not completely delete the data in the built-in hard disk and your personal data
could leak out. To prevent the data from leaking out, execute complete deletion of the
HDD following the procedures below.
1 While the camcorder is in HDD recording pause mode, press , then press
MENU.
2Press f/e to select “HDD Setting”, then press c.
3Press f/e to select “Full Format”, then press the confirmation button.
4Press d to select “YES”, and then press the confirmation button to confirm the
setting and begin HDD full format.
• When transferring or discarding a disc, it is recommended that you physically destroy it
or use deletion exclusive software (generally available) to completely delete the data on
it. It is user’s responsibility to control the data on disc and memory card.
• Hitachi will not accept any responsibility for leaking of personal data.
If the camcorder does not operate normally, perform “System Reset”. The
camcorder may recover to normal. “System Reset” will reset all settings to the
factory defaults. The date and time will also be reset. Set the date and time again
before using the camcorder.
1 Set the power switch to “OFF” to turn the camcorder off.
Detach the battery or AC adapter/charger.
2 Use a fine tipped pen to hold down RESET for
several seconds.
All settings will be reset.
System Reset
Note
Do not press RESET with undue force.