Operating Instructions

English
177
Disc cannot be removed. Did you detach the battery or AC adapter/charger before setting the
power switch to “POWER OFF”?
Connect the battery or AC adapter/charger, set the power switch to
“O VIDEO” and then “POWER OFF”, and remove the disc.
46, 51
DVD video camera/
recorder cannot be
operated from remote
control.
Is the remote control pointed at the infrared receiver on DVD video
camera/recorder?
Point it at the infrared receiver to operate the DVD video camera/
recorder.
36
Is the infrared receiver on DVD video camera/recorder exposed to
direct sunlight or strong fluorescent light, etc.?
The remote control cannot operate the DVD video camera/recorder
when strong light strikes the infrared receiver. Adjust the place or
angle of the DVD video camera/recorder.
36
Is there battery in the remote control?
Also check the polarities of battery. The battery could be dead: Try
replacing it.
35
Is the DVD video camera/recorder powered?
Turn it on.
51
Disc cover cannot be
closed.
Is disc correctly inserted?
Was disc inserted from wrong direction?
Remove the disc and then reinsert it.
47
Is disc inserted in wrong orientation?
Remove the disc, and then reinsert it.
47
Connect a fully charged battery or AC adapter/charger, and then
turn the DVD video camera/recorder on.
42, 46
Cover will not open. Did you disconnect the battery or AC adapter/charger during
removal of disc? Reconnect the battery or AC adapter/charger, and
then turn the DVD video camera/recorder on.
43, 46
Operating sound is heard
cyclically.
This sound is heard because the disc is cyclically operated and does
not indicate a fault.

Some vibrations are felt
or slight sound is heard
from mechanism.
These vibrations or sound are caused by disc drive: This does not
indicate a fault. 
Symptom Cause and Correction
Reference
page