Owner's Manual

163
Additional Information
When the camcorder is connected to a PC
Symptom Cause and Correction
Reference
page
The PC does not
recognize the
camcorder.
Check that the camcorder’s power switch is set to “HDD”
or “DVD”.
22
Turn the PC off and disconnect the USB cable. Then turn
the PC back on and reconnect the cable.
—
Make sure the cable is connected properly to both the PC
and the camcorder.
131
An error occurs
while playing back
movies recorded on
the camcorder using
the PC.
If error occurs with the USB connection, the transfer rate
is not sufficient. It is recommended that you use a USB
terminal conforming to USB2.0 when connecting the
camcorder.
126
The software does
not run correctly on
the PC.
Turn the PC and camcorder off, and try again.
—
An error occurs
during writing to a
disc.
The temperature of the camcorder is too high due to
continuous operation.
Disconnect the camcorder from the PC, remove the disc
from the camcorder, and then turn it off. After a few
moments, connect them again and write to a brand-new
disc.
134
Transfer of images
stops.
Connect the camcorder to another USB terminal of the
PC. If your PC is a desktop type, it is recommended that
you use a USB terminal on the back of the PC. If you are
using USB2.0 extended card, it is also recommended that
you install the newest version driver provided by the
USB2.0 card maker.
126
Is the disc scratched or dirty?
Clean the disc.
170
The DVD drive of
the PC cannot be
used after the
provided software
was installed.
Do you use another software application to edit/write
DVD? There may be a conflict between that software and
the ImageMixer 3 software. This problem may be solved
if you update the other DVD editing/creating software of
your PC.
—
An error appears
when starting
ImageMixer 3.
Make sure that your PC display adapter (video card)
conforms to Direct X
®
9.0c. 126
The DISC EJECT
switch does not work
when the camcorder
is connected to a PC.
While the camcorder is connected to the PC, use Explorer
to right-click the camcorder drive icon and select “Eject”.
132
DZ-HS903-803-US-Ea_IM_v01d05n02.p.book Page 163 Friday, September 12, 2008 8:22 PM