Gigabit Router Configuration Guide

Configuration Error Messages
GR2K-GA-0014 5-33
Ver. 07-02
export: invalid {RIP|RIPng} metric value at
<Metric> not in range 1 to 16
In export definition, the RIP/RIPng metric is invalid. Specify a value
within the range of 1 to 16.
<Metric>: Specified metric value
export: invalid route-filter number value at
<Value> not in range 1 to 65535
The specified ID number is invalid. Specify within the range of 1 to
65535.
<Value>: Specified ID number
export: invalid vpn number value at <Value>
not in range 1 to <Max_Value>
The specified vpn number is invalid. Specify within the range of 1 to
<Max_Value>.
<Value>: Specified VPN number
<Max_Value>Maximum VPN number
export: IPv6 Interface not found at ’<Interface
name>’
The interface of the specified interface name cannot be found.
Specify it by using the defined interface name.
<Interface name>: Specified interface name
export: IPv6 prefix cannot be linklocal in
configuration
The link local address is specified in the network address. Do not use
the link local address.
export: IPv6 prefix cannot be multicast in
configuration
The multicast address is specified in the network address. Do not
use the multicast address.
export: linklocal address should be followed
by % (IPv6 interface name)
An interface name is not specified in the specified link local address.
Specify an interface name with the percent (%) interposed when
specifying a link local address.
export: low end of range <Mask1> shorter
than prefix mask <Mask2>
In the between specification, mask range lower limit value is
overlapped with specified mask. Specify the value so the mask range
does not overlap with specified mask.
<Mask1>: Specified mask range of lower limit
<Mask2>: Specified mask
export: low end of range (<Value1> bits) is
greater than high end (<Value2> bits) is
greater
In the between specification, mask range lower limit value is greater
than upper limit. Reduce lower limit value to less than upper limit
value.
<Value1>: Lower limit of Mask range
<Value2>: Upper limit of Mask range
export: mask not contiguous Bit 1 of specified mask does not continue. Use a mask where bit 1
continues.
export: metric option of route-filter must not be
define for {bgp|bgp4+}
The metric option for the route filter is defined against the BGP/
BGP4+ protocol. Do not specify the metric option.
export: Non-masked bits not zero for
<Address> mask <Mask>
At mask, 1 is set to non-masked bit of specified address. Set
non-masked bit 0.
<Address>: Specified address
<Mask>: Specified mask
export: Non-masked bits not zero for
<Address> masklen <Masklen>
At masklen, 1 is set to non-masked bit of specified address. Set
non-masked bit 0.
export: not IPv6 prefix Addresses other than an IPv6 prefix are specified. Specify the IPv6
prefix.
export: out of range The parameter-specified range is exceeded in the input command
syntax. Numeric values of more than 4294967296 are contained.
Reconfirm a parameter.
export: preference option of route-filter must
not be define for export filter
The preference option for the route filter is defined in the export filter.
Do not specify the preference option.
export: route-filter name "< Name>" cannot be
specified
The specified route filter contains invalid protocol information or
network information. Specify the valid route filter name.
<Name>: Route filter name
export: route-filter name "<Name>" longer
than 15 characters
The specified ID exceeds 15 characters. Specify ID by 15 or less
characters.
<Name>: Specified ID
Table 5-5 Routing Protocol Error Messages (continued)