Gigabit Router Configuration Guide

Configuration Error Messages
GR2K-GA-0014 5-37
Ver. 07-02
import: Non-masked bits not zero for
<Address> masklen <Masklen>
At masklen, 1 is set to non-masked bit of the specified address.
Set non-masked bit 0.
<Address>: Specified address
<Masklen>: Specified mask length
import: not IPv6 prefix Addresses other than an IPv6 prefix are specified. Specify the IPv6
prefix.
import: out of range The parameter-specified range is exceeded in the input command
syntax. Numeric values of more than 4294967296 are contained.
Reconfirm a parameter.
import: proto option of route-filter must not be
define for import filter
The proto option for the route filter is defined in the import filter.
Do not specify the proto option.
import: route-filter name "<Name>" cannot be
specified
The specified route filter contains invalid protocol information or
network information. Specify the valid route filter name.
import: route-filter name "<Name>" longer
than 15 characters
The specified ID exceeds 15 characters. Specify ID by 15 or less
characters.
<Name>: Specified ID
import: route-filter not found at <Value> The specified ID is not defined
Specify a defined ID.
<Value>: Specified ID
import: Set-attribute "<Name>" cannot be
specified
Filter information inherent to IPv4 is defined in IPv6. Do not specify
the filter information inherent to IPv4.
<Name>: Specified identifier
import: Set-attribute not found at <Value> The specified ID number cannot be found.
Specify the defined ID number
<Value>: Specified ID number
import: syntax error Syntax error
import: tag option of route-filter must not be
define for {import filter | bgp | bgp4+ | rip |
ripng}
The tag option for the route filter is defined in the import filter or the
BGP/BGP4+/RIP/RIPng protocol. Do not specify the tag option.
import: tag option of route-filter must not be
define for {import filter | bgp | bgp4+ | rip |
ripng}
The tag option for the route filter is defined in the import filter or the
BGP/BGP4+/RIP/RIPng. Do not specify the tag option.
ip: invalid vpn number value at <Value> not in
range 1 to <Max_Value>
VPN number is out of valid range. Specify value within the range of 1
to <Max_Value>.
<Value>: Specified VPN number
<Max_Value>Maximum VPN number
network-filter: duplicate entry at <Address>
mask <Mask> [exact | refine]
In the network-filter definition, an network range is duplicated.
Specify a unique network range
<Address>: Specified Address
<Mask>: Specified mask
network-filter: duplicate entry at <Prefix>/
<Prefixlen> [exact | refine]
The network range is defined in duplication in the network-filter
definition. Specify the range so that the network range will not be
duplicated.
<Prefix>: Specified prefix
<Prefixlen> Specified prefix length
network-filter: duplicate network-filter at
<Value>
The specified ID has been already registered. Specify the other ID.
<Value>: Specified ID
network-filter: each network must belong to
the same family: <Name>
A network information of different address family is mixed in the
network-filter. Specify the information so does not overlap with
deferent address in one network-filter name.
<Value>: Network filter name
network-filter: invalid high end of range value
at <Value> not in range 0 to {32|128}
In the between specification, upper limit value of mask range is
invalid. Specify a value within the range of 0 to 32/128.
<Value>: Upper limit of specified mask range
Table 5-5 Routing Protocol Error Messages (continued)