Gigabit Router Configuration Guide

Hitachi Gigabit Router GR2000 SeriesEnhanced Version Configuration Commands, Vol. 2
5-48 GR2K-GA-0014
Ver. 07-02
route-filter: invalid vpn number value at
<Value> not in range 1 to <Max_Value>
Vpn number specification range is invalid. Specify value within the
range of 1 to <Max_Value>.
<Value>: Specified vpn number
<Max_Value>Maximum VPN number
route-filter: ipv4 protocol and ipv6 protocol
must not be intermingled: <Name>
ipv4 routing protocol information exists together with ipv6 routing
protocol information. Specify the two information items so that they
do not coexist in one route filter name.
<Name>: Route filter name
route-filter: IPv6 prefix cannot be linklocal in
configuration
The link local address is specified in the network address. Do not use
the link local address.
route-filter: IPv6 prefix cannot be multicast in
configuration
The multicast address is specified in the network address. Do not
use the multicast address.
route-filter: linklocal address should be
followed by %(IPv6 interface name)
An interface name is not specified in the specified link local address.
Specify an interface name with the percent (%) interposed when
specifying a link local address.
route-filter: low end of range <Mask1> shorter
than prefix mask <Mask2>
In the between specification, lower limit of the mask range is
overlapped with specified mask. Correct the value so the mask range
does not overlap with specified mask.
<Mask1>: Lower limit of specified mask range
<Mask2>: Specified mask
route-filter: low end of range (<Value1> bits) is
greater than high end (<Value2> bits)
In the between specification, lower limit of the mask range is greater
than upper limit. Reduce lower limit value of the mask range to less
than upper limit value.
<Value1>: Lower limit of mask range
<Value2>: Upper limit of mask range
route-filter: mask not contiguous Bit 1 of the specified mask does not continue. Use a mask where bit
1 continues.
route-filter: network-filter name "<Name>"
longer than 15 characters
The specified ID exceeds 15 characters. Specify ID by 15 or less
characters.
<Name>: Specified ID
route-filter: network-filter not found at <Value> The specified ID number is not defined. Specify a defined ID number
<Value>: specified ID number
route-filter: Non-masked bits not zero for
<Address> mask <Mask>
At mask, 1 is set to non-masked bit of the specified address. Set
non-masked bit 0.
<Address>: Specified address
<Mask>: Specified mask
route-filter: Non-masked bits not zero for
<Address> masklen <Masklen>
At masklen, 1 is set to non-masked bit of the specified address.
Set non-masked bit 0.
<Address>: Specified address
<Masklen>: Specified mask length
route-filter: not IPv6 prefix Addresses other than an IPv6 prefix are specified. Specify IPv6
prefix.
route-filter: out of range The parameter-specified range is exceeded in the input command
syntax. Numeric values of more than 4294967296 are contained.
Reconfirm a parameter.
route-filter: route-filter name "<Name>" longer
than 15 characters
The specified ID exceeds 15 characters. Specify ID by 15 or less
characters.
<Name>: specified ID
route-filter: route-filter sequence out of order The specified order of a sequence number is incorrect. Specify a in
ascending sequence.
route-filter: Set-attribute not found at <Value> The specified ID number is not defined. Specify a defined ID number
<Value>: Specified ID number
route-filter: syntax error Syntax error
Table 5-5 Routing Protocol Error Messages (continued)