User's Manual
9
Remote Control
Remove the insulating strip of remote control
Remote Control Operation Range
Battery installation for the remote control
CR2025
1
2
30
0
30
0
5m
Remove the insulating mylar
strip from the battery if the
battery is being used for the
¿UVWWLPH,WLVORFDWHGDWWKH
bottom back side of the remote
control.
3RLQWWKHUHPRWHFRQWUROXQLW
no more than 5 meters from
the remote control sensor and
within 60° of the front of the
unit. The operating distance
may vary according to the
brightness of the room.
,IWKHUHPRWHFRQWUROXQLW
fails to work even when it
is operated near the unit,
replace the battery.
1. Press and hold the battery
release tab in the direction of
arrow
1
.
2. Pull out the battery holder
completely in the direction of
arrow
2
as shown in the left.
3. Remove the old battery, and
place a new battery in the
holder.
4. Push the holder back into the
remote control.
Note: Use a 3V lithium battery
(No. CR2025 or equivalent)
Caution: %HFDUHIXOZKHQ
you press the slot of the
battery compartment with your
¿QJHUQDLOVRQO\DVWKLVPLJKW
break them.