User's Manual

14. OUTPUT/SYNC

On this menu screen, you can make signal changeover for output to the D-SUB connector and phase

adjustment for external synchronization.

1) OUTPUT : Output mode changeover

• R, G, B

：

The R, G and B video signals are output to the D-SUB connector.

• Y, R-Y, B-Y

：

The Y, R-Y and B-Y signals are output to the D-SUB connector.

• Y/C

：

The Y/C and VBS signal is output to the D-SUB connector.

2) COLOR BAR : Color bars ON/OFF

3) MONO : Monochrome (black and white) ON/OFF for the video output signal from the VIDEO connector

Set to ON for monochrome. Setting ineffective during color bar.

4) Sync/HD out : Selects sync signal output from the rear panel multi connector.

5) SYNC ON G : G video signal synchronization ON/OFF (In the R/G/B mode only)

When output is RGB with Sync on and G on, Sync is added to the G video signal.

6) GL IN : Impedance changeover of input to the GL IN connector.

• HIGH : The high impedance level is provided.

• 75

: An impedance of 75 ohms is provided.

Note: When power to the camera is turned off, the high impedance level is provided. So, do not use this

function in a system where power is turned off for the camera unit only.