User's Manual

SHEET
5
9
D F 0 2 2 - 4 P E - S 1
2
1
3
4
F
E
D
C
B
A
F
E
D
C
B
A
2
1
3
4
DWG.
No.
6. Specification of Digital output connector
(1) Gigabit Ethernet connector
PIN NO. Signal
1 TRP1+
2 TPR1-
3 TRP2+
4 TPR3+
5 TRP3-
6 TRP2-
7 TRP4+
8 TRP4-
Connector: RJ-45
*LED Status
STATUS LED1(Green) LED2 (Yellow)
Power ON Light Off Light On
Transmission Blink On Light On
Transmission pause Light Off Light On
(2) 12-pin connector
PIN NO. Signal PIN NO. Signal
1 GND (+12V) 7 TRIG-A / VD (H)
2 +12V 8 TRIG-B (C)
3 GND 9 TRIG-B (H)
4 AUX 10 FLASH / VD OUT
5 GND 11 N.C.
6 N.C. 12 TRIG-A / VD (C)
Connector (camera side) : SAMWOO SNH-10-12 (RPCB) or equivalent
Plug (matching cable plug) : Hirose HR10A-10P-12S (01) or equivalent
Please do not unplug and insert cable (camera cable) with a power supplied to a camera.
Install clamp filter (ZCAT 2035-0930A: TDK) at both ends (camera and video processor
ends) in the CE marking legion.
Please do not connect 1 pin and 3/5 pin when using PoE. When connecting it, PoE may stop
the power supply. Because TRIG-A/VD and TRIG-B are photo coupler input, 8/12 pin is
isolated with 1/3/5 pin. When 8/12 pin is connected to GND, please connect to 3 pin or 5 pin.
Note: Please do not input any signal to N.C. pin because machine may break down.
LED1 LED2