Operation Manual

For any help concerning set up and use of your TV please call the Customer Helpline: 0845 604 0105
designed for unattended operation or has a stand-by
mode. Switch off using the switch on the equipment
and make sure that your family know how to do this.
Special arrangements may need to be made for infi rm
or handicapped people.
DON’T continue to operate the equipment if you are in
any doubt about it working normally, or if it is damaged
in any way - switch off, withdraw the mains plug and
consult your dealer.
ABOVE ALL
--- NEVER let anyone especially children push anything
into holes, slots or any other opening in the case - this
could result in a fatal electrical shock;
--- NEVER guess or take chances with electrical equipment
of any kind
--- it is better to be safe than sorry!
Power source
The TV should be operated only from a 220-240V •
AC, 50 Hz outlet.
Warning: When the set is not in use for a long time,
disconnect from the power.
Positioning the TV
For ventilation, please leave a clear space of at •
least 10cm all around the TV.
Do not • block the ventilation openings.
Do not• place the TV on sloping or unstable
surfaces, the TV may tip over.
To prevent damage to the TV, • do not place any
objects on top of the TV.
Only use the TV in moderate climates.•
Power cord and plug
Do not place the set, a piece of furniture, etc. on •
the power cord (mains lead) or pinch the cord.
Handle the power cord by the plug. Do not unplug
the appliance by pulling from the power cord and
never touch the power cord with wet hands as
this could cause a short circuit or electric shock.
Never make a knot in the cord or tie it with other
cords. The power cords should be placed in such
a way that they are not likely to be stepped on. A
damaged power cord can cause fi re or give you
an electric shock. When it is damaged and needs
to be replaced, it should be done by qualifi ed
personnel.
This TV receiver is supplied with a moulded •
mains plug. The mains plug must not be cut off,
as it may contain a special radio interference
fi lter, the removal of which could lead to impaired
performance. If you wish to extend the lead, obtain
an appropriate safety approved extension lead or
consult your dealer.
Observe the manufacturers instructions when •
connecting extension leads to the set. Check the
fuse rating on the new plug; this should be fi tted
with a 5 Amp fuse which conforms to either ASTA
or BSI (BS1362) approvals, these are easily
identifi able by either the
ASA
or symbols. If you
are in any doubt about the installation of an
extension lead, please consult a competent
electrician.
Safety Information
IMPORTANT - Please read these instructions fully before installing or operating
10 cm
10 cm
10 cm
4
01_MB62_ypbpr_[GB]_IDTV (ARGOS)_BRONZE19_1825UK_26915LED_10076298_5020xxxx.indd 4 14.11.2011 19:55:41