user manual

3.6 Saving and Recording Images

3 - 96

3.6.2 Preparing Images for Recording

The source of images to be recorded is frozen images in the image memory except for direct

photographing.

(1) Freezing an image

(a) Using Run/Freeze button

Scanning image will be frozen. When scanning speed is slow, scanning continues to the

end of the frame and then, the image is frozen. Image size is 1280 x 960 pixels in full

screen. It is 640 x 480 pixels in small and dual screen mode.

(b) Capturing an image

During the image capture process, depending on the particular scanning speed

employed, the image is frozen either after integration or after one frame is scanned

slowly. Image size depends on the selected capture resolution (640 x 480, 1280 x 960,

2560 x 1920 or 5120 x 3840 pixels).

After photographing, the image is frozen in the image memory. Image size depends

on the capture resolution selectable with Capture resolution select button (640 x 480,

1280 x 960 or 2560 x 1920 pixels).

(2) The source of image to be recorded

Several commands or buttons are placed on multiple areas. The image sources for the

commands are as follows.

(a) When you use menu commands, or buttons on the control panel, the scanning image

will be used as the image source. Image size depends on the way of freezing, as

mentioned above.

(b) When you use buttons on the Captured Image window, the selected image on the

window is used as the image source. Image size depends on the capture resolution

setting.

(3) Embedding texts and graphics written on the image

(a) Auto Data Display

When the Embed Into Image box in the AUTO Data Display area on the Setup dialog

window - Record tab has been checked, the auto data display is embedded into the

image data when the image is saved. If it is not checked, only the image data is saved.

This setting is also applied for Print, Copy and PCI Transfer commands. If the For

Photograph box is checked, the position of the auto data display in the saved image is

shifted slightly upward to ensure that it is properly framed in photographs. It is

recommended not to check the box if the saved image data will be used on the

computer only.