user manual

6.4.4

6 - 71

(4) Type of Measurement

Specify a type of measurement.

(a) Standard button

Select Standard for a single dimension measurement in X or Y direction or angle.

(b) W&P button

Select this button for simultaneous width and pitch measurement.

Click this for setting successive measurements. This is usable when Standard has

been selected.

(d) Profile check box

Click this for displaying a line profile. This is settable when measurement mode is

Auto.

(5) Mode Selection

Select the measurement mode.

(a) Auto button

Selects auto measurement.

(b) Manual button

Selects manual measurement.

(6) Measurement Direction

Select a measurement direction.

(a) X button

Selects measurement in X (horizontal) direction.

(b) Y button

Selects measurement in Y (vertical) direction.

Selects an angle measurement. This is selectable when measurement mode is

Manual.

(7) Edge Detect Direction

Select an edge detect direction of the cursor box that specifies the position including edge

to be detected, when X or Y has been selected as the measuring direction. This is

selectable when measurement mode is Auto. The icon changes with the type of

measurement and measurement mode. When Angle measurement has been selected,

then select the circle cursor for the side to be measured.