user manual

6.4.5

6 - 93

(f) Drag the cursor with the mouse and align it with the part to be measured, then click

Enter button. Angle measurement can thus be done as in Fig. 6.4-22. Calibration is

not performed in the case of angle measurement.

Fig. 6.4-22 Angle Measurement Result

(2) Successive Manual Measurement

(a) By selecting Multiple under manual measurement mode and under the same

measurement parameters, successive manual measurement can be carried out.

Click Set button on the CD Measurement window and the measurement cursors

appear. In successive measurement, X and Y directions cannot be measured

simultaneously, so you must specify a measuring direction.

(b) Drag the measurement cursor box with the mouse as in the manual measurement,

and align the cursor with the part to be measured. Click Enter button and the

measured result appears.

cursor with the next part to be measured. Click Enter button and the 2nd measured

result will appear after the 1st measured result.

(d) In the same manner, click Set button, align the measurement cursors, and click Enter

button to achieve successive measurement. In manual mode, a maximum of 8

successive measurements can be achieved.

(e) Successive measurement is also possible in the angle measurement mode.

Successive measurement by changing X, Y or Angle midway as in Fig. 6.4-23 is also

feasible. In the case of Angle, numerics will be displayed in the part where the

circular cursor appears.