User Manual

Chapter 7 Explanation of Functions
7 - 15
7.3.6 Output signal delay/hold function
The output signal delay/hold function allows you to set on-delay and off-delay times for each output
terminal.
Since every output signal is turned on or off immediately when the relevant condition is satisfied, signal
chattering may occur if signal outputs conflict with each other. Use this function to avoid such a problem by
holding or delaying specific signal outputs.
To use this function, set on-delay and off-delay times for individual output terminals (a total of two terminals,
such as intelligent output terminals [11] and the alarm relay terminal).
Item Function code Range of data Description
Output 11 on-delay time C130 0.0 to 100.0 (s) Setting of on fot terminal [11]
Output 11 off-delay time C131 0.0 to 100.0 (s) Setting of off for terminal [11]
Output RY on-delay time C140 0.0 to 100.0 (s) Setting of on fot relay terminal
Output RY off-delay time C141 0.0 to 100.0 (s) Setting of off for relay terminal