User Manual

Chapter 7 Explanation of Functions
7 - 47
7.6.7 Select automatic return to the initial display [b164]
If you do not manipulate the operator for 10 minutes, the operator screen automatically changes to the
screen that you set in the (b038).
This function is enabled by setting the b164 = 01.
Item Function code Data Description
Automatic return to the initial
display
b164
00 Disable
01 Enable
7.6.8 NES1-OP display selection [b150]
NES1-OP key does not work when you connect an digital operator or remote operator.
This function sets the monitor code to be displayed in NES1-OP.
Item Function code Data Description
NES1-OP display selection b150 001 to 050 d001 to d050 corresponding to the monitor item
7.6.9 Data Read/Write selection [b166]
This function is to choose whether to allow read / write of data in the WOP.
Item Function code Data Description
Data Read/Write selection b166
00 Enable
01 Disable
See section 7.6.2
7.6.10 Display limitation function (DISP)
To use this function, assign function "86" (DISP) to one of the terminal [1] to [5] functions (C001 to C005).
While the (DISP) input is ON , the operator displays a parameter chosen by initial-screen selection. And
cannot select other parameter.
Item Function code Data Description
Terminal [1] to [5] functions C001 to C005 86 DISP: Display limitation function