Brochure

5
Operation and Programming
<NE-S1 Standard Operator Panel> <Option Operator Panel>
7-segment LED
Shows each parameter, monitors
etc.
Go to the top of next function
group,when function mode is
displayed.
Escape key
RUN key
Makes inverter run.
RS485/RS422 port
RJ45 jack for RS485 and
remote operator.
Run LED
Function code: Moves to the data display.Data
code: Press to write the new value to EEPROM.
Set key
Press up or down to sequence through parameters and
functions.shown on the display, and
increment/decrement values
Up key/ Down key
Potentiometer
●Keypad Navigation Map Single-Digit Edit Mode (At the time of operator use.)
Run command LED
Run / Stop / Reset Key
RJ45 jack for RS485 and
remote operator.
RS485/RS422 port
Makes inverter stop.
Stop / Reset key
Alarm LED
ON when the inverter trips.
ON when the inverter
trips.
Alarm LED
Run LED
Power LED Run activation
indication LED
ON when inverter is in RUN mode.
ON when inverter is in RUN mode.
ON while the inverter is
receiving input power.
Program LED
ON when the display shows
editable parameter.
NE-S1
Step3:
When the least significant digit is
blinking, the SET key selects
that parameter.
Step2:
The blinking digit is moved by the
ESC and SET key right and left.
Use up/down keys to change the
value of the digit.
Group "d"
Function code
Function code display
:
Moves to data display
Data display
Function group "d" is a monitor,
data cannot be changed.
d001: Output frequency monitoring
Group "F"
Function code
Data display
F001: Output frequency setting
Group "A"
Group "b"
Function code
Data display
A001: Frequency source setting
Group "C"
Group "H"
Group "d"
Save
return to d001
Function code display
: Change the value of function code.
Pressing the up key at the bottom of the group returns to the top of the group.
Function code display
: Jumps to the next group
Data display (F001 to F003)
Data does not blink because of real time synchronizing
Data display
When data is changed, the display starts blinking, which
means that new data has not been stored yet.
: The data changes and returns to function code display.
: Cancels the data change and returns to
function code display.
If a target function code or data is far from
current position, using the single-digit edit
mode makes it quicker to navigate there.
Pressing the up key and down key at the same
time brings you into the digit-by-digit navigation
mode.
1st digit will be blinking.
SETESC
+1
-1
Move cursor to left. Move cursor to right.
SET
Step1:
Press both up key and down
key at the same.
Returns to function code display.
)
Change and setting parameter by Keypad (NES1-OP).