Operation Manual

20
Information
How to secure the cables.
After connecting all of the cables to the terminals, secure them with the clamps.
When you secure the cables, please be careful not to tighten too much.
CAUTION
Use only the Power Cord provided.
Do not use a power supply voltage other than that indicated (AC220-240V, 50Hz). It may cause fi re or electric shock.
For the plasma television, a three-core power cord with a ground terminal is used for effi ciency protection. Always be
sure to connect the
Power Cord to a grounded outlet and make sure that the cord is properly grounded. If you use a
power source converter plug, use an outlet with a ground terminal and screw down the ground line.
Connection to a Cable Distribution System is to be provided through a galvanic isolator.
Ensure that both ends of power cord are easily accessible.
If you have to change the power cord, please use the certifi ed power cord that meets your region’s safety standard.
CONNECTION (continued)
Connecting Procedure (continued)
4. Connecting the plug into the wall socket
Connect the Power Cord after completing all other connections.
(The type of plug is different from this drawing for some countries.)
UK only
Except UK
Clamp
After inserting Power Cord in the band clamp,
pull the band in the direction of the arrow.
Band clamp
42” models
How to secure the clamp:
To set
To unfasten
Knob
Push the clump in the
direction of the arrow until
it clicks.
Whilst pushing the knob,
pull it in the direction of the
arrow.
Small clamp (Secure stand cable only.)
Large clamp
After inserting Power Cord in the band clamp,
pull the band in the direction of the arrow.
Band clamp
How to secure the large clamp:
To set
To unfasten
Set the clamp in the
direction of the arrow.
Loosen the hook, and
pull in the direction of the
arrow.
50” models
Hook