Operation Manual

64
TROUBLESHOOTING (continued)
Symptom and Check List (continued)
Symptoms Check list Page
• No picture
The Indicating lamp ĺ Off
• Check if the Power Cord is plugged into the socket fi rmly.
• Check if the Main Power is ON.
20
,
21
• No picture
The Indicating lamp ĺ Pulsing blue
It means that the unit is in “Power Save
mode”.
• Check if all the cables of the external equipments are connected
correctly and fi rmly.
• Check if the power of the external equipments is ON.
• Check if the TV/AV mode has been selected correctly.
• Refer to “Power Save mode” and “When following messages appears
on the screen”.
61
• No picture
The indicating lamp ĺ Blue
• Check if the signal cable is connected correctly and fi rmly.
• Adjust the level of Brightness and Contrast lower.
15
~
18
• The top of the unit and surface of the
panel heat up.
• It may happen when you use the unit for a long time. Turn off the Main
Power of the unit for a whilst. Please note that this is not malfunction.
66
,
68
• The image contrast reduces whilst
displaying still images.
• If still images are left on the screen for more than 2.5 minutes, protection
function will work automatically so that contrast reduces to minimize
image retention on plasma display panel. Please note that this is not
malfunction but it helps to minimize image retention.
The original contrast will restore after moving images are displayed for
about 6 minutes. Original contrast can be restored quickly by turning the
power On/Off with remote control or power switch on the unit.
• When the VCR is in special playback
features (Fast Forward or Rewind), the
screen gets dark and cannot see the
image at all.
• It could happen when the VCR is connected to Component output, such
as 480i. This is not malfunction.
• Try Composite output or S-video output and check the picture again.
• Screen display size cannot be switched
correctly.
• The display size is fi xed at “FULL” when the receiving signals are
720p/60Hz or 720p/50Hz.
50
,
51
• Time information is incorrect. • Adjust time by using “Time Offset” of Function Menu.
35
• Image cannot be displayed from HDMI 1
or 2.
• Check if the cables are connected correctly.
• Check the output format of the equipments.
• (Please refer to “Signal Input” and “Recommended Signal List”.)
66
~
68