Instruction Manual

6.3.5 Self check
Self check of the remote controller PCB can be performed.
During the test, the internal memory of the controller (EEPROM)
can be cleared and reset to factory settings.
1 Select “Self check” on the “Check Menu” screen and press
“OK”.
2 Software version check
Software version is shown. If long press “
” and “ ” for
3 seconds, EEPROM is cleared.
Refer to EEPROM process. Else, turn to Step3.
3 LCD check
Press “OK” and show white screen. Press “
”, screen color
changes.
(Red)
(Blue)
(Black)
(Green)
EN
SERVICE & INSTALLATION MENU
PMML0601 rev.0 - 07/202289