Instruction Manual
Table Of Contents
- 1 Safety summary
- 2 Switch Names and Functions
- 3 Operation
- 4 Icon Description
- 5 Function Menu
- 5.1 Simple Timer Setting
- 5.2 Operation Schedule Setting
- 5.3 Power Savings Setting
- 5.4 Night Quiet Operation
- 5.5 Power Saving/Night Quiet Schedule Setting
- 5.6 Power Consumption Display
- 5.7 Autoboost (QUICK MODE) Setting
- 5.8 Comfort Setting
- 5.9 Motion sensor setting
- 5.10 Setback Setting
- 5.11 Elevating Grille
- 5.12 Filter Reminder Reset Setting
- 5.13 FrostWash
- 5.14 Individual Louver Setting
- 5.15 Cancel Individual Louver Setting
- 5.16 Louver Open/Close
- 5.17 Ventilation
- 5.18 Total Heat Exchanger Setting
- 6 Service & installation menu
- 6.1 Installation menu
- 6.1.1 Test Run
- 6.1.2 Function selection
- 6.1.3 Thermistor Selection
- 6.1.4 Input / Output Setting
- 6.1.5 Thermistor Calibration in Controller
- 6.1.6 Fan Speed at Cooling Thermo-OFF
- 6.1.7 Fan Speed at Heating Thermo-OFF
- 6.1.8 Indoor Unit Address Change
- 6.1.9 Address Check Operation
- 6.1.10 Address Initialization
- 6.1.11 Setting Initialization
- 6.1.12 Main Remote Setting
- 6.1.13 Priority Setting
- 6.1.14 Cancel Preheating Control
- 6.1.15 Elevating grille Setting
- 6.1.16 Power Up Setting
- 6.1.17 Setback Trigger Unit
- 6.1.18 Refrigerant Leak Sensor Setting
- 6.2 Service menu
- 6.3 Check Menu
- 6.1 Installation menu
- 7 Screen Display Setting menu
- 8 Contact Information menu
- 9 Hotel Mode Setting
- 10 In Alarm Condition
3 Press " " to lower the grille until it's lowered to the set
distance.
• If it is necessary to further lower the grille (more than the set
value), press “
” again.
• Each press lowers the grille by 20in (50cm).
• Pressing "
" can stop the grille at any position while it is
lowering.
4 After cleaning the air lter, install the air lter and press " " to
raise the grille. Once the grille is stored inside the unit, it will
stop after approximately 3 seconds.
• If the grille is tilted when stored, press " " again until the tilt
is corrected.
• Pressing "
" can stop the grille at any position while it is
raising.
5 Press”
” to return to the indoor unit selection screen.
To operate other indoor units, perform the operations of
above Step2.
To end the operation, press “
” again to return to the
“Function Menu” screen.
• If there is only one indoor unit, the screen returns to the
“Function Menu” screen.
5.12 FILTER REMINDER RESET SETTING
This function is used to turn off the lter reminder indication and
to reset the time of use for the lter.
1 Select “Reset Filter Reminder Time” on the “Function Menu”
screen and press “OK”.
2 Press “ ” or “ ” to select “Yes”, and then press “OK”.
• The screen returns to the "Function Menu" screen depending
on the type of the indoor unit.
3 Press “OK” and the screen returns to the “Function Menu”
screen.
EN
FUNCTION MENU
PMML0601 rev.0 - 07/202227