Instruction Manual
Table Of Contents
- 1 Safety summary
- 2 Switch Names and Functions
- 3 Operation
- 4 Icon Description
- 5 Function Menu
- 5.1 Simple Timer Setting
- 5.2 Operation Schedule Setting
- 5.3 Power Savings Setting
- 5.4 Night Quiet Operation
- 5.5 Power Saving/Night Quiet Schedule Setting
- 5.6 Power Consumption Display
- 5.7 Autoboost (QUICK MODE) Setting
- 5.8 Comfort Setting
- 5.9 Motion sensor setting
- 5.10 Setback Setting
- 5.11 Elevating Grille
- 5.12 Filter Reminder Reset Setting
- 5.13 FrostWash
- 5.14 Individual Louver Setting
- 5.15 Cancel Individual Louver Setting
- 5.16 Louver Open/Close
- 5.17 Ventilation
- 5.18 Total Heat Exchanger Setting
- 6 Service & installation menu
- 6.1 Installation menu
- 6.1.1 Test Run
- 6.1.2 Function selection
- 6.1.3 Thermistor Selection
- 6.1.4 Input / Output Setting
- 6.1.5 Thermistor Calibration in Controller
- 6.1.6 Fan Speed at Cooling Thermo-OFF
- 6.1.7 Fan Speed at Heating Thermo-OFF
- 6.1.8 Indoor Unit Address Change
- 6.1.9 Address Check Operation
- 6.1.10 Address Initialization
- 6.1.11 Setting Initialization
- 6.1.12 Main Remote Setting
- 6.1.13 Priority Setting
- 6.1.14 Cancel Preheating Control
- 6.1.15 Elevating grille Setting
- 6.1.16 Power Up Setting
- 6.1.17 Setback Trigger Unit
- 6.1.18 Refrigerant Leak Sensor Setting
- 6.2 Service menu
- 6.3 Check Menu
- 6.1 Installation menu
- 7 Screen Display Setting menu
- 8 Contact Information menu
- 9 Hotel Mode Setting
- 10 In Alarm Condition
6 Press “ ” and select “Yes”. The address change processing
starts. The result is displayed after a few seconds.
If the address is changed successfully, the word “Completed”
is displayed. Otherwise, the process may have failed. Verify
the settings.
7 When changing multiple indoor units’ address, select
“Continuous” and press “OK”. When nishing, select
“Complete” and press “OK”.
6.1.9 Address Check Operation
This function allows the user to check the addresses of indoor
units when several units are controlled from the same wired
remote controller. Using this function, the user can operate
individually each indoor unit after having selected a specic unit
address.
1 Select “Address Check Operation”on the “Installation Menu”
screen and press “OK”.
2 Press “ ”, “ ”, “ ” or “ ” to select the indoor unit. Press “OK”.
3 Once the indoor unit is selected, press the “ ” button
to operate the unit. Check that the selected address is
matching with the desired indoor unit on the installation.
Once done, press again the
“
” button to stop the unit.
Select another unit and repeat this sequence if necessary.
4 When the air conditioner is OFF, press “ ”, the screen
returns to the “Installation Menu” screen.
EN
SERVICE & INSTALLATION MENU
PMML0601 rev.0 - 07/202263