Instruction Manual
Table Of Contents
- 1 Safety summary
- 2 Switch Names and Functions
- 3 Operation
- 4 Icon Description
- 5 Function Menu
- 5.1 Simple Timer Setting
- 5.2 Operation Schedule Setting
- 5.3 Power Savings Setting
- 5.4 Night Quiet Operation
- 5.5 Power Saving/Night Quiet Schedule Setting
- 5.6 Power Consumption Display
- 5.7 Autoboost (QUICK MODE) Setting
- 5.8 Comfort Setting
- 5.9 Motion sensor setting
- 5.10 Setback Setting
- 5.11 Elevating Grille
- 5.12 Filter Reminder Reset Setting
- 5.13 FrostWash
- 5.14 Individual Louver Setting
- 5.15 Cancel Individual Louver Setting
- 5.16 Louver Open/Close
- 5.17 Ventilation
- 5.18 Total Heat Exchanger Setting
- 6 Service & installation menu
- 6.1 Installation menu
- 6.1.1 Test Run
- 6.1.2 Function selection
- 6.1.3 Thermistor Selection
- 6.1.4 Input / Output Setting
- 6.1.5 Thermistor Calibration in Controller
- 6.1.6 Fan Speed at Cooling Thermo-OFF
- 6.1.7 Fan Speed at Heating Thermo-OFF
- 6.1.8 Indoor Unit Address Change
- 6.1.9 Address Check Operation
- 6.1.10 Address Initialization
- 6.1.11 Setting Initialization
- 6.1.12 Main Remote Setting
- 6.1.13 Priority Setting
- 6.1.14 Cancel Preheating Control
- 6.1.15 Elevating grille Setting
- 6.1.16 Power Up Setting
- 6.1.17 Setback Trigger Unit
- 6.1.18 Refrigerant Leak Sensor Setting
- 6.2 Service menu
- 6.3 Check Menu
- 6.1 Installation menu
- 7 Screen Display Setting menu
- 8 Contact Information menu
- 9 Hotel Mode Setting
- 10 In Alarm Condition
6.1.18 Refrigerant Leak Sensor Setting
Function only available for those indoor units that are equipped
with refrigerant leak sensor. Current European indoor units
series are not equipped yet with this device, then the refrigerant
leak sensor menu will have no action.
Select “Refrigerant Leak Sensor Setting” on the “Installation
Menu” and press “OK”.
Reset Alarm
1 Select “Reset Alarm” on the “Refrigerant Leak Sensor
Setting” menu and press “OK”.
2 Select “Yes” on the conrmation screen and press “OK”.
Test Run
1 Select “Test Run” on the “Refrigerant Leak Sensor Setting”
menu and press “OK”.
2 By pressing “ ”, or “ ” move between “Operation Mode”, “Fan
speed”, “Louver” and “Test Time” controls.
By pressing “
” or “ ” change the setting of the selected
control.
3 Press “ ” in order to set the test run and to return to the
“Refrigerant Leak Sensor Setting” menu.
SERVICE & INSTALLATION MENU
PMML0601 rev.0 - 07/202270