Operation Manual

– 15 –

Cleaning and maintenance must be carried out when filter lamp lights. Before cleaning, stop

operation and switch off the power supply.

1. AIR FILTER

Clean the filter, as it removes dust inside the room. In case the air filter is full of dust, the air flow will

decrease and the cooling capacity will be reduced. Further, noise may occur. Be sure to clean the

filter following the procedure below.

CAUTION

Open the front panel and remove the filter.

Gently lift and remove the air filters

from the

air filter frame.

Vacuum dust from the Pre-filter and air

filter using vacuum cleaner. If there is

too much

dust, rinse under running tap water

and gently

brush it with soft bristle brush. Allow

filters to

dry in shade.

Re-insert the air filter to the filter

frame.

Set the Pre-filter with “FRONT” mark

facing

front, and slot them into the original

state.

After attaching the filters, push the front panel

at three arrow portions as shown in figure and

closeit.

CAUTION

Do not wash with hot water at more than 40°C. The filters may shrink.

When washing it, shake off moisture completely and dry it in the shade; do not expose it directly to

the sun. The filters may shrink.

PROCEDURE

HSILGNE