Operation Manual

– 14 –
RAR-3R5
RAR-3R5
MANUAL OPERATION (HEATING, DEHUMIDIFYING, COOLING, DRY COOL)
Select the operation mode.
Press the (OPERATION
SELECTOR) button.
• Any one of Heating, Dehumidifying,
Cooling, Dry Cool or Auto can be
selected.
• To start Fan operation, perform
Stainless Plasma Air Purifying
(FAN) operation. (Page 18)
•
If the (OPERATION SELECTOR)
button is pressed during operation,
a double short beep is heard on
Auto mode while a single short beep
is heard on other mode.
Set the fan speed.
Set the room temperature.
Set the humidity (only for
dehumidifying and Dry Cool modes)
Operation starts.
Press the (START/STOP) button.
Press the
(START/STOP) button again.
• A short beep sounds and the operation stops.
• From next time, the operation that has been set on the above procedure 1~4
can be performed just by pressing the (START/STOP) button.
n Humidity setting range
40~70%
n Remote controller temperature setting range
Heating, Cooling, Dry Cool 16~32°C
Dehumidifying 10~32°C
2
1
One of them lights up. One of them lights up.
Press the (HUMIDITY) button.
• The humidity can be set in
increments of 5%.
• Humidity indication disappears in
approximately 10 seconds if the
operation is not started.
Increase
Decrease
4
3
Lights up.
Lights up.
5
STOP
• Outdoor temperature -20°C~21°C
(When it is below 20°C or over 24°C, the heating
function may not operate in order to protect the
device.)
Heating Dehumidifying Dry Cool Cooling
•
Outdoor temperature
1°C~35°C
(Operation does not start if the
room temperature is below 1°C. )
• Outdoor
temperature
25°C~35°C
• Outdoor
temperature
22°C~43°C
• Do not use cooling operation in winter.
Press the (FAN SPEED) button.
• Any one of “AUTO”, “HI”, “MED”,
“LOW”, “SILENT” can be selected.
Fan speed indication disappears
in approximately 10 seconds if the
operation is not started.
• If the (FAN SPEED) button is
pressed during operation, a double
short beep is heard on Auto mode
while a single short beep is heard
on other mode.
Press the (ROOM
TEMPERATURE) button.
• Room temperature indication
disappears in approximately 10 seconds
if the operation is not started.
• If the (ROOM TEMPERATURE)
button is pressed during operation,
a double short beep is heard at
20°C, a triple short beep at 30°C,
and a single short beep on other
temperature.
Increase
Decrease
Use the air conditioner following the operation conditions outlined below.