Operation Manual

– 23 –
ENGLISH
DEUTSCHFRANÇAISITALIANOSPANISHPORTUGUÊS
∂ÏÏËÓÈο
РУССКИЙ
PREFERENCE (COOLER/WARMER) OPERATION
Press the (PREFERENCE) button until “COOLER/WARMER”
indicator turns off on the remote controller.
CANCEL
• When the (PREFERENCE) button is pressed during the Dry Cool operation activated by (DRY COOL)
button, the air conditioner performs the Preference (Cooler/Warmer) operation.
• When “Cooler” is set in the Preference operation, the airflow will be extended so that the air can reach even
further. (Extended Airflow)
Press the
(PREFERENCE) button during Dry Cool
operation.
• A short beep sounds and the Preference (Cooler/Warmer)
operation starts.
Every time you press it, the mode will change as shown
in the chart on the right.
• Cannot be set on Dry Cool operation during manual
operation. (Page 14)
• This operation mode can be set only during Dry Cool operation which has been activated by pressing the
(DRY COOL) button. It is not available during manual Dry Cool operation.
Cooler
Warmer
Operation mode
Operating mechanism
• Temperature is set lower than the preset temperature by approximately 1°C.
Airflow direction is set to downwards so that users can feel the airflow.
• Temperature is set higher than the preset temperature by approximately 1°C.
Airflow direction is set to upwards direction to prevent direct airflow.