Operation Manual

– 39 –
ENGLISH
DEUTSCHFRANÇAISITALIANOSPANISHPORTUGUÊS
∂ÏÏËÓÈο
РУССКИЙ
Maintenance of dust catcher
No daily maintenance is required. However, filter should be cleaned if the dirt is noticeable due to the
environment in which the air conditioner is used.
Some type of dust may not go in the dust box but be accumulated on the rear surface of the dust catcher.
It is recommended to check the dust amount on the dust catcher approximately once every 2 years and
clean the dust catcher if it is dirty.
1
Stop the operation with the remote controller and unplug
the power plug (or turn off the circuit breaker).
Hook
Hook
2
3
4
(For front use)
(For top use)
Remove the front panel.
(Refer to page 37 on removing the front panel)
Remove the dust catcher.
• Remove the dust catcher for the
top and front face as shown with
arrows.
• If dust is accumulated at the
inner side of the dust catcher,
remove the dust with a vacuum
cleaner.
5
Wash with water.
• Please wash with water.
• If the dirt is stubborn, use a mild detergent and wash with warm
water below 40°C.
• Dry completely in the shade.
Attach the dust catcher.
• Hold the dust catcher for the top face with its side having the lever facing towards you. Insert and push
in the dust catcher in the arrow direction until it clicks.
• Hold the dust catcher for the front face with its side having the lever facing upward. Insert its bottom side
and then push in the dust catcher in the arrow direction until it clicks.
6
Attach the front panel.
(Refer to page 38 on attaching the front panel)
7
Plug in the power plug (or turn on the circuit breaker).
Improper installation of the dust catcher could result in malfunction. Filter cleaning operation can not
be performed properly and the (CLEAN) indicator blinks.
CAUTION