User Manual

UNITS INSTALLATION
10-10
• After connecting the pipes and connecting cord, be
sure to screw PIPE SUPPORT tightly and fix the
pipes and connecting cord.
• Position the easy-to-attach side of PIPE
SUPPORT (after aligning it with the pipe) to face
the front and secure it with a screw. (Be sure to
install PIPE SUPPORT to prevent rodents from
entering the indoor unit.)
• To prevent the pipe connector from contacting the
front cover, push the connector as fsr as it goes.
• Arrange the connecting cord, pipes and drain hose
neatly and store them in the bottom section of the
rear surface of the indoor unit.
- Pipe layout of the unit rear
surface
- Pipe/drain hose layout
when passing through the
file in a wall
 CAUTION
• When mounting the flare insulator , make sure
there is a space between the insulator and left of
resin part. Otherwise, may cause water dripping.
Fixing the indoor unit
1. Floor installation
a. Drill holes on wall
(As shown below)
b. Push plug into the holes
(As shown below)
Fixing on the wall
Fixing on the hanger
Fixing the base of indoor unit
• Fix the base of indoor unit on the floor with
4.1x3.2mm screws (right and left).
• When fixing the indoor unit above the ground,
be sure to fix an L-angle at the bottom to
support it.
Hook the PIPE
SUPPORT tab in
the square hole.
Screw
PIPE SUPPORT
Mount PIPE SUPPORT so that the
cylindrical portion of the drain pan passes
through its hole and sucure it with screws
located at the right back corner.
Indoor unit
rear surface
Connecting
cord
Pip
Insulator
Insulator
Drain hose
Connecting
cord
Pip
Wall
Wall
Screw
Cabinet
Plug
Screw
Screw
Φ 9 rear
fixing hole
for anchor
bolt or
screw of
accessory
184mm or less
438
440
155
55
Screw
Screw
Screw (4.1x32)
Screw (4.1x32)