User Manual

UNITS INSTALLATION
10-38
Inlet air direction change instructions
5. Installation of wired remote controller
a. Connection to the electrical box
• Remove the cover of electric box
• Connect the connector of wired remote
controller to CN1102.
• Assemble back the cover of electrical
box
b. Wiring installation for wired remote controller (2
methods)
• Wired remote controller casing can be
opened by pressing the slots with minus
screw driver (see below diagram)
• Decide the fixing location of remote
controller so that the length of wire shall
be within 15 meters.
 CAUTION
• Do not cut the provided wire. Excess wire should be
properly wound and fitted at safe place
• Do not join the wire with additional wire.
• When connecting the wires via the wall’s recessed
slot:
7. Fix the bottom casing to the wall by the provided screw
8. Assemble the top casing to the fixed bottom casing.
(Refer to the illustration below for detail installation
After unscrew the
bond, put the wired
remote control cord
and fix back with
screw
Wired
remote
controller
Remote
controller
Top casing
Bottom casing
CN1102