Indoor Furnishings User Manual

LTIP/UX21511, UX21513

REPLACEMENT LAMP FOR HITACHI LCD REAR PROJECTION TELEVISION

MODELS 42V515 / 42V710 / 42V715 / 50V500E / 60V500E / 50V500 / 50V500A / 50VX500 / 60VX500 / 60V500A /

50V710 / 50V715 / 60V710 / 60V715

REPLACING THE LAMP

USER INSTRUCTIONS

CAUTION:

Do not attempt to remove the lamp immediately after use; doing so can cause serious burns. Prior to removing lamp, switch

off the power supply to the television and wait approximately 60 minutes or more to allow for complete lamp cooling.

Avoid touching the glass portion(s) of the lamp with bare hands; fingerprints, dirt and dust may cause early lamp failure

and/or image obscurity. It is recommended that gloves be worn when replacing the lamp.

When transporting the replacement lamp, use the box that is provided to avoid breakage.

To avoid overheating and/or fire, ensure that the replacement lamp is mounted securely.

The lamp contains mercury. Dispose of it in accordance with local environmental regulations. For disposal or

recycling information, contact your local authorities or see www.lamprecycle.org.

WARNING:

1. Switch off power to the television. Unplug the power cord from the wall outlet. Allow the television to cool

for at least 1 hour.

3. Using a Phillips head screwdriver, remove the

screw securing the lamp cover; remove the cover.

4. Remove the two screws on the lamp unit.

5. Remove the lamp unit from the television by

grasping the handle and pulling it out. Dispose of

lamp in accordance with local environmental

regulations.

Note: To avoid injury, exercise caution when

removing the lamp unit and do not place your hand

in the lamp storage area.

2. Remove the front cover of the television by

pulling it outwards until the snap unlatches.

p. 1

PAGE 1
LTIP/UX21511, UX21513 REPLACEMENT LAMP FOR HITACHI ® LCD REAR PROJECTION TELEVISION MODELS 42V515 / 42V710 / 42V715 / 50V500E / 60V500E / 50V500 / 50V500A / 50VX500 / 60VX500 / 60V500A / 50V710 / 50V715 / 60V710 / 60V715 USER INSTRUCTIONS . CAUTION: Do not attempt to remove the lamp immediately after use; doing so can cause serious burns. Prior to removing lamp, switch off the power supply to the television and wait approximately 60 minutes or more to allow for complete lamp cooling. .
PAGE 2
6. Insert the new lamp unit, paying attention to the orientation and direction of insertion. Ensure that the new unit is firmly seated. Note: To avoid shortened lamp life and/or reduced picture quality, do not touch the glass portion of the new lamp. 7. Tighten the screws firmly on the new lamp unit, taking care not to overtighten. 8. Replace the lamp cover by re-engaging the two clips; tighten the screw on the lamp cover. 9.