Owner's Manual

RECORDING

NOTE: If any menu is activated on the TV screen, the REC button on the remote control does not function. Press

RESET/EXIT button to clear the menu. Then, press REC button.

4 Stop recording

Press STOP button when recording is completed.

SKIPPING UNWANTED SCENES DURING RECORDING

Press PAUSE button to temporarily stop recording.

Press PAUSE or REC button to resume recording.

PAUSE

NOTE: When the VCR is in the Pause mode, you may view the time remaining with n

n marks on the TV screen. Each n

mark represents one minute. After five minutes, the VCR will automatically switch to the Stop mode to prevent tape

damage. When there is 1 minute remaining, one n

n will flash.

RECORDING ONE PROGRAM AND VIEWING ANOTHER

You can record one program while viewing another. To start recording, follow steps [1] to [3] under "VIEWING AND

RECORDING THE SAME PROGRAM".

To select the channel you want to view at the TV, follow the steps below.

NOTE: If you have a cable box or satellite box connected to this VCR, please refer to "ANTENNA/CABLE

CONNECTIONS" on pages 11 and 12 before proceeding to the next step.

4 Select the TV mode

Press VCR/TV button on the remote control so that the "VCR" indicator on the VCR's digital display disappears.

5 Select the channel on the TV

Set the TV to the channel you want to watch.

TO MONITOR THE PROGRESS OF YOUR RECORDING

1 Select the VCR mode

Press VCR/TV button on the remote control so that the "VCR" indicator appears on the display.

2 Select channel 3 or 4 on the TV

Turn on the TV and set the TV to channel 3 or 4. Now set the CH3/CH4 switch on the back of the VCR to match the channel

selected on the TV.