Operation Manual

24
After Sales Support
Telephone:
1300 886 649
Email: info@tempoaustralia.com.au
Recording (Cont.)
Important notes
When using the USB/Media function, remember the following important points:
We strongly recommend you back up all data in the USB storage device
to another storage device so you do not risk losing any data in case of an
unexpected device failure or accident. We do not assume liability for any
loss of data due to misuse or malfunction. Data backup is your personal
responsibility.
You cannot change to a channel from another broadcaster or select
another function while in recording mode.
If the signal is interrupted or removed while in recording mode, the record-
ing will stop until the signal is established. This may cause you to lose
program content.
Do not turn the TV off during recording, otherwise the TV will exit the
time-shift function and turn to standby mode.
The file recorded can only be used in this TV. Do not copy it to any other
device.
When you are in time-shift recording mode, you may experience some
difficulty with a scheduled recording at different times without removing
the USB recording device. You will need to remove the USB device as it is
required to reset after each recording to protect the device from damage.
If you see the message ‘DISK NOT READY’ displayed, remove the device,
reconnect and proceed with your recording.
Some USB storage devices may not be compatible for smooth operation
with this TV.
For large file sizes and large capacity storage devices, the loading speed
may be longer. The recognition speed of a USB storage device may vary
depending on the device.
When connecting or disconnecting the USB storage device, ensure the TV
is not in USB mode, otherwise the USB device or the files stored in it may
be damaged.
Only use a USB storage device formatted in a FAT32 file system provided
with the Windows operating system. If it is formatted by a different utility
program that is not supported by Windows, it may not be recognised.
Ensure any USB devices connected to the TV do not use/exceed 500mA
power rating.
If an “Unsupported File” message is displayed, the file format or codec is
unsupported or corrupted.