User's Manual

11
How to Install the One Touch Joint
便捷連接器的安裝
1
Confirm the diameter of the water tap.
確認水龍頭直徑。

If the diameter exceeds 2cm, remove
the joint ring.
若水龍頭的外徑超過 2cm ，可將連接環
取出。

Screw joint B in the arrow direction to
adjust the gap.
沿箭咀方向旋轉接頭 B 調整間隙。

For water supply hose installation, please refer to "How to install water supply hose" in the user manual.
供水管的安裝參閱使用說明書中『供水管的安裝』一章。

Loosening may occur with extended use. In such case, reinstall the joint following steps 2 to 4.
長時間使用後，可能會因鬆脫而引起漏水，此時請按 2 ~ 4 的步驟重新安裝。
(Carry out the same steps when reinstalling the one touch joint at a change of residence, etc.)
(搬家等需重新安裝便捷連接器時，請按照相同的步驟進行。)
Horizontal tap A
橫式 A 型水龍頭
Horizontal tap B
橫式 B 型水龍頭
Square mouth tap
方口水龍頭
Universal household tap
萬能水龍頭
Swivel tap
萬向水龍頭
2
3
4
Tighten joint B in the arrow direction
to reduce the gap between joint A
and B to 4mm or less.
沿箭咀方向擰緊接頭B，使接頭A、B
之間的間隙在 4mm 以內。
Check the distance between
joints A and B.
確認接頭 A 、 B 之間的間隙。
Press the sealed pad evenly against the
tap and tighten the four screws in a uniform
fashion.
將密封墊均勻地壓在水龍頭上，再將4個螺釘
均等地擰緊。
Appropriate water tap
適用的水龍頭
Horizontal taps A and B as shown below.
橫式 A 、 B 型水龍頭最為適宜。