User's Manual

47
The lid is not locked
completely
(The lid is not completely
closed)
機蓋沒有完全鎖緊
(機蓋沒有完全關閉時)
Is there foreign substance under
the lid?
機蓋下有異物?
Flash of indicator
指示燈閃動
Alarm content
警報內容
Part to check
檢查部位
Solution
處理方法
Troubleshooting
排除異常
Restart operation
再次
動運轉
Are the washings oblique?
衣物有無偏斜?
Or is the washing machine placed
straight? See page 7
洗衣機是否水平放置?
7
Please press the
"START/PAUSE"
button to pause
the operation,
rearrange the
laundry evenly,
and restart with
the lid closed.
請按下暫停按鈕暫
停運轉,調整衣物
平衡後,關閉機蓋
重新動。
If there is still
trouble, stop
using the unit
and request
repair.
若仍出錯,請停止
使用並僱人修理
If the above abnormal alarms occur, they may be caused by outside interference.
At that time, please press the PAUSE button to suspend the washing machine, then restart it. If the same
alarms occur, please stop the use and request repair.
若出現上述之外的異常警報,有可能是由外來乾擾導致。
此時請按下暫停按鈕暫停運轉,然後重新動,若仍出現相同的異常警報,請停止使用並僱人修理。
Case 現象 Cause 原因
Before the repair request Please recheck the following items
要求修理前 請再次檢查以下項目
Press "PAUSE" button, and then
restart it.
按下暫停按鈕,然後重新
Lock of lid can not be
unlocked
機蓋鎖緊無法解除
Fail to running
不運轉
Is power cut?
是否停電?
Does fuse or breaker blow?
保險絲或熔斷器是否燒斷?
Can the power plug enter the socket properly?
電源插頭是否可靠地插入電源插座?
Is the power switch on?
電源開關是否打開?
Is the tap turned on?
水龍頭是否打開?
Is the "Preset washing process" set?
是否設定了“預校洗衣程序”?
31
Whether the "START" button is pressed or not?
有無按下
動按鈕?
Washing basket can
not rotate
(washing, rinsing, spinning)
洗衣槽無法旋轉
(洗衣、沖洗、脫水)