User's Manual

48
Can not open the lid
機蓋打不開
If there is outage and shutdown during the operation, the washing
machine will generate alarms and cut off the power supply. The
lid is still locked. When power supply is switched on again, the
lid lock will be unlocked.
電源開關是否打開?
(運轉過程中出現斷電或停電時,洗衣機將發出異常警報並自動切斷電
源,機蓋仍處於鎖定狀態。再次接通電源後,機蓋鎖定將解除。)
Unable to air-jet dry
無法風乾
Please refer to "The Approximate air-jet duration of laundry".
37
請參照“衣物的大致風乾時間”。
37
Fail to supply water
不供水
No spinning, washing
basket can't rotate
不脫水、洗衣槽無法旋轉
No stirring
不攪拌
Please refer to "Part to check" in "About abnormality alarm". 46
請參照“關於異常警報”中的『檢查部位』。 46
It doesn't work after setting
of air-jet dry
設定風乾後無法工作
if there is water remained in the dehydrating basket, Start
button can not be pressed. And it can only be pressed after
draining all of the water.
脫水槽中有水積存時,就不能接受“
動”鍵,要先進行排水,把水
排光後再按“
動”。
Abnormal sound occurs
發出異常聲音
Is the washing machine declining or shaky? 7 Installation Guide
洗衣機是否有傾斜或搖晃? 7 安裝指南
Is any barrette or metal item mixed in the washing basket?
有無髮夾或金屬物體混入洗衣槽內?
No buzz at the end of washing
洗衣結束後無蜂鳴聲
Is the buzz at the end of washing set as canceled? 18
是否已設定取消洗衣結束蜂鳴聲?
18
The lid can't be opened during
the operation.
運轉過程中,機蓋無法打開
The washing machine has been set the safety protection mode
during the operation. If opening the lid, please press the
"START/PAUSE" button.
18
本機在運轉過程中就已經設定了安全保護模式,如要打開機蓋請按
“啟動/暫停”鍵。
18
Water leakage
漏水
Is the tap of proper shape? 12
水龍頭的形狀是否合適?
12
Are the one touch joint and the connection nut unfastened?
12, 13
便捷連接器和連接螺母是否出現鬆動? 12, 13
Is the water drainage hose inserted into the water drainage joint
properly? Is the hose clipper well positioned?
910
排水管是否切實地插入排水接頭?軟管夾子是否夾到位?
910
Case 現象 Cause 原因
When Failure Happens (continued)
有故障發生時(續)
Except the failures metioned above, the lid lock protector may cause cases such as stop during operation or lid
unable to be opened. In such case, please unplug the power supply unit. Plug it back after 5 minutes, and then
reset operation.
除了上述故障外,如發生運行中途停止或機蓋無法打開的現象,是童鎖開關保護器動作。此時,請拔下電源插頭,五分鐘
後再插上,重新設定並運行即可。
AJ-S70KXP / AJ-S65KXP
If all indicators turn off during operation but only the water drainage pump remains in operation, this is the
auto operation of protection circuit in washing machine. This is not an error.
After water drainage pump stops, please reconnect the power supply and reassign the setting.
如果所有指示燈在運轉過程中熄滅,但只有排水泵仍在運轉,這是因為洗衣機中保護電路在自動運行。這並非故障。
排水泵停止運轉後,請重新連接電源並進行設置。