User's Manual

8
Installation Guide (continued)
安裝指南（續）
■ To install the machine on an inclined floor, leg caps in the attached accessory kit can be used to adjust height by
connecting them to the fixed leg.
安裝在傾斜的地面上時，請將附有的腳套套在固定腳上進行調整。
■ Confirming the machine type of AJ-S70KXP/AJ-S65KXP, please install the water drainage hose and hang it on.
Otherwise there will be no water in washing basket.
9
AJ-S70KXP/AJ-S65KXP 機型確認時，請先安裝排水管並將其連起 / 排水管的安裝及固定方法。
9
否則洗衣槽內無法盛水。
BC
Installation of Washing Machine 洗衣機的安裝
1
Adjust the instability of the washing
machine with adjustable leg.
用可調機腳來調整洗衣機的不平穩。
2
Please make sure of the horizontality of the
washing machine.
請確認機體的水平度。

As shown in the figure, the horizontality can be easily
observed by the string used to hang an object.
如圖所示，用懸掛重物的細繩來觀察，即可輕易確認其
水平度。
Fixed leg
固定腳
Adjustable leg
可調機腳
It is level if the
clearance between A
and machine body is
the same with that
between a and the
machine body.
A和A 兩點與機體
之間的間隙相同，
即表示水平。
string
細繩
A
A
object
重物
(front or
profile)
（正面或
側面）
Put some water into the washing barrel and reconfirm its
horizontality.
在洗衣槽內放些水，請再一次確認其水平度。

The ground is level if all front, rear, left and right height difference between
the spinning hole and water surface are less than 3mm.
脫水孔相對於水面的高度差(B與C的差)，如果前後左右均在3mm以內，就
表示地面是水平的。
Inspection of trial run 試運轉的檢查
How to Use the Adjustable Leg 可調機腳的使用
1
Loosen the lock nut by unscrewing in
arrow direction 1 before using the
adjustable leg to stabilize unit.
將鎖緊螺母沿箭咀方向 1 旋鬆，再旋轉可
調機腳調整機身的平穩。
2
After adjusting of the unit, tighten
the lock nut by screwing it in arrow
direction.
調整完畢後，將鎖緊螺母沿箭咀方向 2
旋緊。
Lowering
調低時
Loosening
旋鬆
Lock nut
鎖緊螺母
Adjustable leg
可調機腳
Elevating
調高時
Maximum adjust able
range is 40mm.
調節範圍在40mm以內。
Tightening
旋緊
Lock nut
鎖緊螺母
Plastic base
塑料底盤
Tighten the lock nut until it reaches the plastic base.
鎖緊螺母應擰至塑料底盤為止。
At most 40mm
40mm以下